|Sears Craftsman RAS side
||Have a question call, 859-494-0790 or
These steps should not be
used if the saw is going to be used in the rip mode, like a table saw.
In addition to the installation instructions these steps are provided.
1. Remove the kickback dogs from the kickback arm
2 Slide the B-15 bracket on to the threaded stud so that the side without
a hole is to the left of the kickback.
3. Use the nut from kickback to secure the bracket.
4. Follow the alignment instructions that were supplied with the Laserkerf.
WARNING: If the saw is ever used for ripping
remove the laser and reinstall the kick back dogs.