In addition to the installation instructions these steps are provided.
1. Remove 1/2 of the protective covering of 1 of the 2 pieces of tape
on the B-6 bracket.
2. Place the bracket on the saw approximately as shown.
3 . Hold the laser on the back of the bracket and move the saw down and make sure that the bracket and laser
do not hit anything. Turn the saw to 45 degrees and move the saw down to
check or clearance. If the bracket or laser hit anything adjust the bracket.
4 . Mark the position of the bracket and remove it from the saw. Remove
the remainder of the tape covering.
5 . Re-attach the bracket at the marks made in step 4.
6. Follow the instalation instructions to align the laser.